Select Page

GC 65

Standards

The machines are complete with:

  • Motorized lifting of the table on 4 screws
  • Abrasive belts 670×2150 mm
  • Rubber covered sprung pressure rollers
  • Emergency limiting bar
  • Automatic table positioner
  • 6-position mechanic positioner for grain replacement
  • 2 infeed table rollers
  • 2 outfeed table rollers
  • Height electronic read-out
  • Variable feeding speed of the mat 4-20 m/1′
  • Belt-safety emergency
  • Automatic belt oscillation
  • Ferodo belt braking system
  • Automatic star-delta start
  • Ammeter
  • ‘CE’ standards

Technical Data

Useful working width 650 mm
Useful working height 160 mm
Min. working height 3 mm
Abrasive belt length 670×2150 mm
Abrasive belt speed 1st roller 18 m/sec
Abrasive belt speed 2nd roller 16 m/sec
Belt motor power 10 (7,5) hp (kw)
Lifting table motor power 0,35 hp
Feeding gear motor power 0,75 hp
Variable feeding speed of the mat 4-20 m/1′
Working pressure 6 bar
Total air consumption 20-30 nl/1′
Suction dust hood dia. 60 mm

Optional

1 BELT EXCLUSION WITH PNEUMATIC CONTROL from panel board
2 BELTS EXCLUSION WITH PNEUMATIC CONTROL from panel board
STIFF PAD EXCLUSION FROM CONTROL BOARD for stiff pad only
FRONT PULL-OUT CONVEYOR ROLLER 300 MM
BACK PULL-OUT CONVEYOR ROLLER 300 MM
AUTOMATIC CENTERING OF THE MAT
1 BLOWER FOR CLEANING ABRASIVE BELT
2 BLOWERS FOR CLEANING ABRASIVE BELTS
TIMING PNEUMATIC TIME PAD  Recommended for veneer (RT-RRT)
Complete with exclusion from control board
DIFFERENCE FOR VOLTAGE OTHER THAN 400/50
MOTOR POWER 15 HP

GC 65/1-150 RT

GC 65/2-150 RR

GC 65/2-150 RRT